Filter
Top Products
ENGLISH
15
VITAL CHECKS AND CARE PROCEDURES TO BE CONDUCTED BY THE OWNER OR THE MECHANIC
Check transmission oil level ●
Check cooling liquid level ●
Check brake fluid level ●
Check brake pads for wear ●
Check brake performance ●●
Lubricate and adjust actuating cables and nipples ●
Remove and clean dust sleeves of telescopic fork at regular intervals ●
Clean and lubricate chain, check tension and readjust it if necessary ●●
Clean air filter and filter box ●
Check tire inflation pressure and wear ●
Check fuel line for leaks ●
Drain and clean float chamber ●
Verify smooth operation of all controls ●
Treat exposed metal components (except for the brake and exhaust systems) ●
with wax-based anti-corrosion agents
Check all screws, nuts, and hose clamps for their tight fit at regular intervals ●
for cross
country use
once a year
after every
cleaning
before each
start
RECOMMENDED INSPECTION OF THE MINI LC ENGINE BY YOUR KTM WORKSHOP
(ADDITIONAL ORDER FOR THE KTM WORKSHOP)
Check the reed-type intake valve for wear ●●●●●●
Check the clutch shoes for wear ●●●●●●
Check the length of the clutch springs ●●●●●●
Check the clutch drum for wear ●●●●●●
Check the water pump shaft and bearings for wear ●●●●●●
Check the water pump wheel for wear ●●●●●●
Check the cylinder and piston for wear ●●●●●●
Check the eccentricity of the crankshaft journal ●●●●●●
Check the radial clearance of the conrod bearings ●●●
Check the radial clearance of the piston pin main bearing ●●●
Check the crankshaft main bearing for wear ●●●
Replace the crankshaft bearings and conrod bearings ●●●
Check the entire transmission including bearings for wear ●●●
30
hours
45
hours
60
hours
90
hours
120
hours
135
hours
NOTE: IFTHE INSPECTION ESTABLISHES THAT PERMISSIBLE TOLERANCES ARE EXCEEDED, THE RESPECTIVE COMPONENTS MUST BE REPLACED.