Filter
Top Products
ENGLISH
33
To facilitate bleeding of the oil system, we have added a hose connection
piece and a plastic hose to the set of tools. Take an empty oil can (1 liter)
and drill a 7 mm-diameter hole into the lid. Screw the hose connection
piece into the lid from the outside, and secure it from the inside with the
M8 hexagon nut.
Slip the plastic hose onto the hose connection piece, and you will have your
filling tool.
Fill 0.6 liters of engine oil into the can and remove the plug
1 next to the
steering head. Introduce the plastic hose into the vent hole
B, (see page
30) and fill 0.6 liters of engine oil into the frame’s front tube. Remove pla-
stic hose, start engine, and let it idle (approx. 20 seconds) until oil escapes
at the hole
B. As soon as oil starts to escape, turn off the engine, and
mount the plug together with the gasket.
Let the motor run until it warms. Check the oil drain plugs and the fine
screen filter to make sure they are properly sealed. Check the level of the
motor oil. Place the motorcycle on a horizontal surface (main stand) and
wait for 5 minutes. Remove the dip stick and wipe it with a piece of cloth
SCREW THE DIPSTICK IN ALL THE WAY AND REMOVE IT AGAIN.
The oil level should be between the two marks on the oil dipstick, however,
it must never rise above the MAX mark.
Otherwise, engine oil would get into the air filter box by way of the engine
venting system.
Add engine oil, if necessary.
!
CAUTION
!
–I
NSUFFICIENT OIL OR POOR QUALITY OIL RESULTS IN PREMATURE WEAR OF THE ENGINE.
–C
HECKING THE ENGINE OIL LEVEL WHEN THE ENGINE IS COLD RESULTS IN A FALSE REA-
DING ON THE OIL DIPSTICK AND THEREFORE AN INCORRECT OIL LEVEL.
–DO NOT OVERFILL THE ENGINE CASE.
–D
O NOT UNDERFILL THE ENGINE CASE.
Afterwards check the entire oil system and motor to make sure they are
properly sealed. Attach the covering of the fine screen filter to the frame
breast pipe.
N
OTE: DISPOSE OF USED OIL PROPERLY
! UNDER NO CIRCUMSTANCES MAY USED OIL BE
DISPOSED OF IN THE SEWAGE SYSTEM OR IN THE OPEN COUNTRYSIDE
. 1 LITER OIL CON-
TAMINATES 1.000.000 LITER WATER
Changing oil filter *
Replace the oil filter when changing the engine oil. Press the foot brake
pedal and place a screwdriver or similar between foot brake pedal and
stopper roll so that the oil filter cover is more accessible. Remove banjo bolt
4
and the three screws. Remove oil filter cover
5
and oil filter. Clean filter
housing, oil filter cover, and sealing surfaces. Check oil duct in oil filter
cover if clogged.
Check the O-ring
6
for damage. O-rings need not be replaced unless
damaged. Press the O-ring into the groove of the filter cover. Fit new oil
filter
7
with rubber gasket on the fitting in oil filter cover and mount cover
with filter. Mount three screws and tighten with 5 Nm (4 ft.lb). Mount
hollow screw with seal rings and tighten with 15 Nm (11 ft.lb). Start engine
and check oil system for leakage.
4
5
6
7
4
5
B
1