Filter
Top Products
ENGLISH
24
Dismounting and mounting the rear wheel*
Park the motorcycle on the center stand. The rear wheel must not touch the
ground.
Loosen the collar nut
1, remove chain tensioner 2, hold the rear wheel
and pull out the wheel spindle
3 until the rear wheel is free but the brake
caliper support is still held. Push the rear wheel as far forward as possible,
take the chain from the rear sprocket and carefully take the rear wheel out
of the swingarm.
!
CAUTION
!
–D
O NOT OPERATE THE REAR BRAKE WHEN THE REAR WHEEL HAS BEEN DISMOUNTED.
–ALWAYS PLACE THE WHEEL ON THE GROUND WITH THE BRAKE DISC POINTING
UPWARDS
. OTHERWISE THE BRAKE DISC MAY BE DAMAGED.
–I
F THE AXLE IS DISMOUNTED, CLEAN THE THREAD OF THE WHEEL SPINDLE AND
COLLAR NUT THOROUGHLY AND APPLY A NEW COAT OF GREASE
(SHELL ADVANCE
GREASE
) TO PREVENT THE THREAD FROM JAMMING.
NOTE:
IF THE REAR WHEEL HAS BEEN DISMOUNTED
, YOU SHOULD ALSO CHECK THE
SHOCK ABSORPTION RUBBER
.
The rear wheel is remounted in reverse order. Before tightening the collar
nut to 80 Nm (60 ft.lb), push the rear wheel forwards so that the chain
tensioners lie on the tension screws.
ƽ
WARNING
ƽ
–I
F YOU DON’T HAPPEN TO HAVE A TORQUE WRENCH AT HAND, MAKE SURE YOU
HAVE THE TIGHTENING TORQUE CORRECTED BY A
KTM DEALER AS SOON AS
POSSIBLE
. A LOOSE WHEEL SPINDLE MAY LEAD TO AN UNSTABLE DRIVING BEHAVIOR
OF YOUR MOTORCYCLE
.
–A
FTER MOUNTING THE REAR WHEEL, KEEP OPERATING THE FOOTBRAKE UNTIL THE
PRESSURE POINT RETURNS
.
–IT IS VERY IMPORTANT TO KEEP THE BRAKE DISK FREE FROM OIL AND GREASE
, OTHER-
WISE THE BRAKING EFFECT WOULD BE STRONGLY REDUCED.
Checking the shock absorption rubbers in the rear hub*
LC4-E models have a damped rear wheel hub. For this purpose, the engine
power is conveyed from the rear sprocket via 6 shock absorption rubbers
4
to the rear wheel. These 6 absorption rubbers wear with increasing
operation time, and should be checked for wear whenever the rear wheel is
dismounted.
For this purpose, lie the rear wheel on a work bench with the rear sprocket
upwards, and put the wheel spindle in the hub. Now hold the rear wheel
firmly and try to turn the rear sprocket. The rear sprocket may not turn
more than maximum 5 mm (0,2 in) measured on the outside. If the play in
the chain wheel is larger, all 6 shock absorption rubbers are to be replaced.
Check the shock absorption rubbers for signs of damage and dirt.
!
CAUTION
!
I
F THE SHOCK ABSORPTION RUBBERS ARE NOT REPLACED IN GOOD TIME, THE REAR
SPROCKET CARRIER AND THE REAR HUB WILL BE DAMAGED
. ALLWAYS REPLACE ALL
6
ABSORPTION RUBBERS, NEVER SINGLE RUBBERS.
1
2
3
3
max. 5 mm
4