JVC TH-S66 Automobile Alarm User Manual


 
Connections
11
The satellite speakers are equipped with their speaker cords attached directly to their speaker unit instead of having speaker terminals on their
cabinet.
CAUTION
When you connect speakers other than the supplied ones, use
speakers of the same speaker impedance (SPEAKER IMPEDANCE)
indicated near the speaker terminals on the rear of the powered
subwoofer.
DO NOT connect more than one speaker to one speaker terminal.
Precautions for daily use
When moving the speakers, do not pull the speaker cords;
otherwise, the speakers may fall over, causing damage or injury.
Do not reproduce sounds at so high a volume that they are
distorted; otherwise, the speakers may be damaged by internal
heat buildup.
4
16
FROM
XV-THC3
XV-THS55
XV-THS58
XV-THS66
Connect the black cords to the black (r) terminals.
Connect the white cords to the (q) terminals
referring to the table below:
Speaker cord
FRONT SPEAKERS (LEFT) White
FRONT SPEAKERS (RIGHT) Red
CENTER SPEAKER Green
SURROUND SPEAKERS (LEFT) Blue
SURROUND SPEAKERS (RIGHT) Gray
Before connecting the speaker cords;
Twist and pull the insulation coat off and remove.
Powered subwoofer
SP-PWS55
Front speakers
SP-THS55F
Surround speakers
SP-THS55S
Center speaker
SP-THS55C
This page is for
TH-S55
Do not connect the power cord until all other connections have been made.
TH-S66-S55[B].book Page 11 Friday, January 14, 2005 10:40 PM