Filter
Top Products
4444
REPLACEMENT PARTS - LYNX SX - 3PPROCEDURE 8
R
E
P
L
A
C
E
M
E
N
T
P
A
R
T
S
L
Y
N
X
S
X
3
P
This Procedure Includes the Following:
Replacing Tiller Charge Port Cover
WARNING
After ANY adjustments, repair or service and
BEFORE use, make sure that all attaching hard-
ware is tightened securely - otherwise injury or
damage may occur.
Turn Power OFF and remove key from igni-
tion. Disconnect battery harness from the
motor lead.
REPLACING TILLER CHARGER
PORT COVER (FIGURE 1)
NOTE: Save the two (2) mounting screws and self-
locking nuts for reuse when installing the NEW tiller
charger port cover.
1. Remove the two (2) mounting screws and self-
locking nuts securing the tiller charger port cover
to the tiller assembly.
2. Remove the tiller charger port cover from the tiller
assembly.
3. Align the mounting holes in the NEW tiller charger
port cover with the mounting holes in the tiller
assembly.
4. Secure the NEW tiller charger port cover to the
tiller assembly using the two (2) EXISTING mount-
ing screws and self-locking nuts. Securely tighten.
FIGURE 1 - REPLACING TILLER CHARGER
PORT COVER
Mounting
Holes
Self-locking
nuts
Tiller
Charger
Port Cover
Mounting
Screws
Tiller
Assembly