Invacare SX-3P Motor Scooter User Manual


 
4040
PROCEDURE 7 CONTROLLER
C
O
N
T
R
O
L
L
E
R
5. Connect the RED and BLACK connectors of the
power wiring harnesses to the RED and BLACK
connectors of the controller wiring harnesses.
6. Connect the WHITE connector of the transaxle
assembly wiring harness to the WHITE connec-
tor of the controller wiring harness.
NOTE: Be sure the metal connectors are in the po-
sitions noted in STEP 4 of REMOVAL.
7. Connect the metal connectors of the power wir-
ing harnesses to the metal connectors of the cir-
cuit breaker.
8. Connect the BLUE connector of the tiller wiring
harness to the BLUE connector of the controller
wiring harness.
9. Connect the YELLOW connector of the tiller wir-
ing harness to the YELLOW connector of the
controller wiring harness.
10. Reinstall the rear shroud. Refer to
REMOVING/
INSTALLING THE REAR SHROUD in PROCE-
DURE 9 of the Owners Manual, part number
1090132.
11. Reinstall the seat. Refer to
REMOVING/IN-
STALLING THE SEAT in PROCEDURE 5 of the
Owners Manual, part number 1090132.
Retaining Tabs
Cable Ties
White Connector -
Transaxle Assembly
Rear Frame
Metal Connectors -
Circuit Breaker
Black Connectors -
Controller Wiring Harness
Yellow Connectors - Controller
Wiring Harness
Red Connector - Power
Wiring Harness
Cable Tie
White Connector -
Controller Wiring Harness
Red Connector - Controller
Wiring Harness
Metal Connectors -
Controller Wiring Harness
Black Connectors - Power
Wiring Harness
Yellow Connectors - Tiller
Wiring Harness
Blue Connectors - Tiller
Wiring Harness
Blue Connectors - Controller
Wiring Harness
FIGURE 3 - REMOVING/INSTALLING CONTROLLER HARNESSES - LYNX SX - 3P AND LYNX SX 3
Tiller Wiring Harness
Lynx LX - 3 and Panther LX - 4
(FIGURE 4)
REMOVING.
1. Disconnect the controller wires. Refer to DISCON-
NECTING/CONNECTING CONTROLLER
WIRES in this procedure of the manual.
2. Disconnect the RED and BLACK connectors of the
power wiring harnesses from the RED and BLACK
connectors of the controller wiring harnesses.
3. Disconnect the WHITE connector of the transaxle
assembly wiring harness from the WHITE con-
nector of the controller wiring harness.
NOTE: Note of the positions of the metal connectors
before removing for proper reinstallation.
4. Disconnect the metal connectors of the control-
ler wiring harnesses from the metal connectors
of the circuit breaker.
5. Disconnect the BLUE connector of the tiller wir-
ing harness from the BLUE connector of the con-
troller wiring harness.
6. Disconnect the YELLOW connector of the tiller
wiring harness from the YELLOW connector of
the controller wiring harness.
Transaxle Wiring Harness
Power Wiring Harness
Tiller Wiring Harness