Humminbird 408930-1 GPS Receiver User Manual


 
65
Navigate to a Waypoint or Position
Navigate to the Cursor Position: From the Chart or Combo View, use the
4-WAY Cursor Control key to move the cursor to a position or waypoint on the
display. Press the GOTO key.
Navigate to a Selected Waypoint: Press the GOTO key. Press the DOWN Cursor
key to highlight a waypoint from the saved waypoints list, and press the RIGHT
Cursor key to start navigation.
Navigate to a Waypoint from the Waypoint Management Dialog Box: Open
the Waypoint Management dialog box. Select a Waypoint, and press the RIGHT
Cursor key to open the Waypoint submenu. Select Go To, and press the RIGHT
Cursor key.
Skip a Waypoint: From the Navigation X-Press™ Menu, select Skip Next
Waypoint, and press the RIGHT Cursor key. If there is not another waypoint to
skip to, navigation will be canceled.
Cancel Navigation: From the Navigation X-Press™ Menu, select Cancel
Navigation, and press the RIGHT Cursor key. Canceling navigation removes the
route and any waypoints created using the GOTO key, but it does not remove
any saved routes from memory. You will be prompted to save the current route
when you cancel navigation.
NOTE: By repeating theprevious instructions,youcan addmore waypointsto
create a longer multi-segment route.
Introduction to Navigation