Honeywell KA 54 Radar Detector User Manual


 
N
KRA 405B RADAR ALTIMETER INSTALLATION MANUAL
Page 2-23
006-10536-0010 Rev. 10 Oct/2005
1. Loosen fluted retaining screw clamp, located on
the front of the mounting rack, remove triangular
keeper from the front lip of the unit, and slide
unit out of the rack.
2. Remove (4) #6-32 screws, securing unit to mounts,
and remove.
(2) Re-installation
a. For Rack Mount, follow procedure outlined in step 1,
For Shock Mount and Direct Mount, follow procedure out-
lined in step 2,
1. Slide the unit into the rack. Hook the triangular
keeper over the front lip of the unit and tighten
the fluted retaining screw clamp located on the
front of the mounting rack until secure.
2. Align unit with mounting holes and secure with (4)
#6-32 screws.
b. Re-attach mating cable to Cannon connector (P4051) on
the front of the unit.
c. Re-attach mating coaxial cables to XMIT (P4052) and RCVR
(P4053) TNC connectors on the front of the unit.
B. KNI 415/416 INDICATOR
(refer to FIGURE 2-5 KNI 415/416 INSTALLATION DRAWING for details)
(1) Removal
a. Detach mating cable from Cannon connector (P4151/P4161)
on the back of the unit.
b. Remove (4) #6-32 screws, securing unit to panel. Unit
may be front or rear mounted relative to panel.
(2) Re-installation
a. Align unit with panel mounting holes and secure with (4)
#6-32 screws. Unit may be front or rear mounted rela-
tive to panel.