Filter
Top Products
N
KRA 405B RADAR ALTIMETER INSTALLATION MANUAL
Page 2-1
006-10536-0010 Rev. 10 Oct/2005
SECTION II
INSTALLATION
2.1 GENERAL INFORMATION
This section contains general suggestions and information to consider
before installation of the KRA 405B. Close adherence to these suggestions
will assure optimum performance from the equipment.
The conditions and tests required for the TSO and MOPS approval of this
article are minimum performance standards. It is the responsibility of
those installing this article either on or with a specified type or class
of aircraft to determine that the aircraft installation conditions are
within the TSO and MOPS standards. These articles must have separate
approval for installation in an aircraft. Any features in this equipment
outside the requirements of this applicable TSO and MOPS must be evaluated
and approved as part of the installation approval. The article may be
installed only if performed under 14 CFR part 43 or the applicable
airworthiness requirements.
The unit may be installed only if further evaluation by the applicant
documents an acceptable installation and is approved by the Administrator.
2.2 UNPACKING AND INSPECTING EQUIPMENT
Exercise extreme care when unpacking the equipment. Make a visual
inspection of the unit for evidence of damage incurred during shipment.
If a claim for damage is to be made, save the shipping container to
substantiate the claim. The claim should be promptly filed with the
transportation company.
It would be advisable to retain the container and packaging material after
all equipment has been removed in the event that equipment storage or
reshipment should become necessary.
2.3 EQUIPMENT INSTALLATION
The KRA 405B should be installed in accordance with standards established
by the customer’s installing agency, and existing conditions as to unit
location and type of installation. However, the following suggestions
should be considered before installing the system. Close adherence to
these suggestions will assure a more satisfactory performance from the
equipment.
The locations chosen for units of the KRA 405B Radar System and the methods
of installation will vary with each particular type of aircraft. The units
should be installed in a convenient location for ease of operation and
accessibility for inspection and maintenance.