Havis-Shields C-TSM-CHGR-X Automobile Parts User Manual


  Open as PDF
of 2
 
INSTALL INSTRUCTIONS C-TSM-CHGR-X
TRUNK SIDE MOUNT FOR 2006-2008 DODGE CHARGER
X = “D” DRIVERS SIDE OR “P” PASSENGER SIDE
TOOLS REQUIRED:
Ratcheting wrench
Utility knife or Jig Saw
Screwdriver set
Powered drill w/ 1/8” & 3/16” drill bits
HARDWARE:
QTY DESCRIPTION PART #
3 10-32 Keps nuts GSM30028
3 10-32 x ½” Phillips machine screws GSM33118
3 #10 x ¾” Sheet metal screws GSM33195
Always!
Read all instructions before installing any Havis-Shields Equipment Corp products.
Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes!
Use hardware provided with install kit
Empty view of passenger
side mounting location
Notch trim as necessary
Note: Vehicles w/ carpeted
fiberglass trim requires more
cutting due to thickness of material,
see next page.
Position trunk side mount and
determine where to notch vehicle trim
in order to function properly
Cut carpeted fiberglass trim along
this line for proper fit.
Position Trunk Side Mount and
mark (3) holes on top mounting
bracket
Pre-drill lower mounting holes
using 1/8” drill bit and attach with
#10 x ¾” Sheet metal screws
Cut