Havis-Shields C-CUP2 Series Automobile Accessories User Manual


 
C-CUP2-INST-6-06
Installation Instructions
C-CUP2 SERIES CUPHOLDERS
TOOLS REQUIRED:
Torx TX20 Driver
Adjustable wrench (panel mount only)
Phillips screwdriver
Warning: Please read all instructions and warnings prior to installation. This product must be installed
and used in accordance with FMVSS, vehicle manufacturer, and all applicable laws, codes, and
specifications. These instructions are provided as a guideline for proper installation, and do not
purport to cover every possible installation scenario or configuration. If questions arise, consult the
factory.
INSTALLATION:
There are four standard installation types, as listed below. Please follow the instructions applicable
to your specific installation:
C-CUP2-I Internal mount for enclosed consoles:
1. The internal-mount cupholder requires
4” of mounting space.
2. First, select the optimum location for
installing the cupholder. Carefully
remove any equipment/panels already
installed in that location.
3. Using the hardware supplied, secure the
cupholder bracket only to the console
(without the plastic cupholder insert
being installed.)
4. Install the plastic cupholder insert by
pressing it firmly into the bracket.
Install the two rubber cupholder pads by
pressing them firmly into each cup
location, if they are not already installed.
5. Replace any necessary equipment/panels
to complete installation, ensuring that
they are installed correctly.
C-CUP2-E-AS or C-CUP2-E-C External mount to rear end-of-console extrusion:
1. Most end-of-console mounted
cupholders should be installed using this
method.
2. First, remove any existing cupholders or
other accessories that will interfere with
the installation of the new cupholder.
3. Remove the two screws holding the
endcap onto the extrusion. Remove the
plastic endcap (note that it may be held
with adhesive.)
4. Using the hardware supplied, install the
cupholder bracket only (without the plastic
cupholder insert being installed.)
5. Install the plastic cupholder insert by
pressing it firmly into the bracket.
Install the two rubber cupholder pads by
pressing them firmly into each cup
location, if they are not already installed.