Harbor Freight Tools 94564 Automobile Accessories User Manual


 
Page 16SKU 94564 For technical questions, please call 1-800-444-3353.
Phase 10:
3/4” THICK PLY-
3/4” THICK PLY-
3/8”
CARRIAGE BOLT
3/8”
WASHER
3/8”
LOCK WASHER*
3/8”
NUT
3/8”
HARDWARE
&
PLYWOOD
(NOT INCLUDED)
FIGURE J
To install a Bed for the Trailer, cut two pieces of 3/4” thick plywood (not included)
at 48” x 48”. NOTE: It may be necessary to slightly trim the plywood to t.
(See Figure J.)
Mark 7 locations in each piece of plywood to correspond with the 14 mounting holes
located on the front and rear Cross Members (2A, 2B) and Left and Right Side Rails
(1FL, 1FR, 1RL, 1RR). Set the plywood aside, and drill the 14 marked locations
with a 3/8” bit. Then, replace the plywood on the Trailer frame. (See Figure J.)
Secure the two pieces of plywood to the front and rear Cross Members (2A, 2B) and
Left and Right Side Rails (1FL, 1FR, 1RL, 1RR), using 3/8” diameter, rust resistant
Carriage Bolts, Washers, Lock Washers, and Nuts (none included). Make sure the
bolt heads do not protrude up through the plywood. (See Figure J.)
1.
2.
3.