Harbor Freight Tools 93229 Automobile Accessories User Manual


 
SKU 93228 / 93229 For technical questions please call 1-800-444-3353. Page 3
9. Do not allow children to play with the Flush Mount Tail Light.
10. Always check hardware and assembled parts after assembling. All connections should be
tight and hardware tightened.
11. Make certain to follow all local laws regarding vehicles and Tail Lights.
12. Do not cut or rewire any part of the Tail Light.
13. Make certain the vehicle is turned off before doing any maintenance.
Warning: The warnings, cautions, and instructions discussed in this instruction manual cannot
cover all possible conditions and situations that may occur. It must be understood by
the operator that common sense and caution are factors which cannot be built into
this product, but must be supplied by the operator.
Assembly
Your 4” Flush-mount Tail Lights will require complete installation. It is important that you read the
entire manual to become familiar with the product BEFORE you install and use the 4” Flush-Mount
Tail Lights. Before operating this product be sure that you have all parts described in the Parts List
and Assembly Diagram located on page 4 of this manual. If you do not have experience doing this
type of electrical work, the job should be done by an automotive service technician.
1. Make certain that the vehicle’s engine is OFF before doing any maintenance. Proceed with the
following steps for installing the 4” Flush-mount Tail Lights.
2. Use a pin connector or inline splice connector (both not included) to connect the Tail Lights to
your vehicle. When using an inline splice connector, it is not necessary to strip the wires.
3. Insert two positive wires to the appropriate wires in your vehicle’s lighting system. Insert one
wire from your vehicle into one channel of the inline splice connector. Insert the wire from the
Tail Light into the second channel of the inline splice connector. Fold down the tab on the inline
splice connector to make the connection. Insert the second wire in the same fashion.
4. Make certain that the black wire is connected to metal on the vehicle to provide a ground.
Unpacking
When unpacking your 4” Flush-Mount Tail Lights, check to make sure that all parts listed in the parts
list on page 4 are included. If any parts are missing or broken, please call HARBOR FREIGHT
TOOLS at 1-800-444-3353.