Filter
Top Products
Page 6
SKU 92923 For technical questions, please call 1-800-444-3353
Controls and Indicators
Bleeding Brakes and Adding New Fluid
WARNING: The vehicle engine must never be started in a closed garage, or any
other sealed structure. Carbon monoxide is produced during operation and is deadly
in a closed environment. Early signs of carbon monoxide poisoning resemble the flu,
with headaches, dizziness, or nausea. If you have any of these signs get fresh air im-
mediately.
1. Place the Brake Fluid Exchanger near the vehicle and remove the Tank Cap (2).
2. Open and secure the engine hood and find the Master Cylinder.
3. Remove the Master Cylinder Lid.
4. Open the Adapter Kit and find the Adapter Lid that looks like, and best fits, the Master
Cylinder.
Refer to the Adapter Kit Parts List at the end of this manual. The temporary Adapter
Lid should have the form of the Master Cylinder Lid with the addition of a connector
inlet for the Fluid Hose (20). In some instances, a universal Lid (E1, F1, or F2) may
need to be used where other Adapters will not fit. Use the mounting loop cables and
hardware provided with the Adapter to secure the universal Lid.
Air Release Safety
Valve (18)
Air Connector Ball
Valve (15)
Air Hose
Quick Connector (14)
Pressure
Adjust
Valve (16)
Air Release
Ball Valve (15)
Tank Cap (2)
Fluid Hose (20)
Pressure
Gauge (23)
Add Brake
Fluid Here
CONNECT TO THE QUICK
CONNECTOR (14) ON THE
BRAKE FLUID EXCHANGER
REV 04/06