Filter
Top Products
Page 6SKU 92840 For technical questions, please call 1-800-444-3353
Operation
Raising the Vehicle
Note: This Two Stage Jack comes with two Adapters (1). The two Adapters (1) are stored by
the wheels of the Jack (see FIGURES 2 and 3).
Note: The Handle is adjustable. You can position it into any of the slots shown in FIGURE 3
below by pulling the Handle Position Lever, and moving the Handle until the lever drops
into place (see FIGURE 1 on page 5).
Warning! The Jack and vehicle being lifted must be stable when lifted so they do not
fall and cause personal injury. Keep spectators away from the work area. Read
the vehicle manual to find the proper lifting points for the vehicle.
1. Position the Jack under the vehicle to be lifted is at one of the recommended lifting
points. Connect to the air source and turn on the compressor. Turn the Lever (27) to
the right toward the UP arrow on the Controls (see FIGURE 1 on page 5). Lift the load
slightly and check that the load is stable on the jack. If not, lower the load and check
that the vehicle has no load on it and that the jack is in the proper position. Allow the
Jack to rise to the desired level, and then move the Lever (27) into the neutral position
between the UP and DOWN positions (shown in FIGURE 1).
2. Place jack stands (not included) under the vehicle before attempting to do any
work on, in, under, or around the vehicle.
FIGURE 2
Both Adapter (1) extensions on.
Adapter (1)
Adapter (1)
FIGURE 3