Harbor Freight Tools 69596 Automobile Parts User Manual


 
Page 2 For technical questions, please call 1-800-444-3353. Item 69596
69597
WARNING SYMBOLS AND DEFINITIONS
This is the safety alert symbol. It is used to alert you to
potential personal injury hazards. Obey all safety messages
that follow this symbol to avoid possible injury or death.
Indicates a hazardous situation which, if not avoided,
will result in death or serious injury.
Indicates a hazardous situation which, if not avoided,
could result in death or serious injury.
Indicates a hazardous situation which, if not avoided,
could result in minor or moderate injury.
Addresses practices not related to personal injury.
Important Safety Information
Failure to heed these warnings may result in personal
injury and/or property damage:
1. Study, understand, and follow all
instructions before operating this device.
2. Do not exceed rated capacity.
3. Use only on hard, level surfaces.
4. Center load on saddle.
5. Use as matched pair to support
one end of a vehicle only.
6. Wear ANSI-approved safety goggles
and heavy-duty work gloves during use.
7. Do not use for aircraft purposes.
8. Support vehicle only at manufacturer-
recommended locations.
9. Inspect before every use; do not use
if parts loose or damaged. Do not use
if even a minor crack, bend or other
damage/deformation appears. Discard
Jack Stand if damaged or deformed.
10. To prevent serious injury,
bend in tab after inserting bar.
11. This product is not a toy. Do not allow
children to play with or near this item.
12. Use as intended only.
13. Inspect before every use; do not use
if parts are loose or damaged.
14. Be aware of dynamic loading!
Sudden load movement may
briefly create excess load
causing product failure.
15. Keep work area clean and well lighted.
16. Do not use stand when you are tired or
under the influence of alcohol or drugs.
Read warning labels on prescriptions to
determine if your judgment or reflexes
are impaired while taking drugs. If there
is any doubt, do not operate the stand.
17. Only use on a dry, level, flat surface,
free of grease or debris. The surface
must be capable of supporting the
combined weight of vehicle and Stands.
18. Maintain product labels and
nameplates. These carry
important safety information.
If unreadable or missing, contact
Harbor Freight Tools for a replacement.