Filter
Top Products
SKU 68048, 6049, 6056 For technical questions, please call 1-800-444-3353 Page: 1
Save This Manual
Keep this manual for the safety warnings and precautions,
assembly, operating, inspection, maintenance and cleaning
procedures. Write the product’s serial number on the front
page of the user’s manual (or month and year of purchase
if product has no number). Keep this manual and the
receipt in a safe and dry place for future reference.
Important Safety Information
In this manual, on the labeling, and all other information
provided with this product:
This is the safety alert symbol. It is used to alert
you to potential personal injury hazards. Obey
all safety messages that follow this symbol to
avoid possible injury or death.
DANGER indicates a hazardous situation which, if not
avoided, will result in death or serious injury.
WARNING indicates a hazardous situation which, if not
avoided, could result in death or serious injury.
CAUTION, used with the safety alert symbol, indicates a
hazardous situation which, if not avoided, could result in
minor or moderate injury.
NOTICE is used to address practices not related to
personal injury.
CAUTION, without the safety alert symbol, is used to
address practices not related to personal injury.
There may be some slight differences in the appearance
of the various manually-operated oor jacks, however
the instructions in this manual apply to all of such jacks
provided by Harbor Freight Tools.
Safety Warnings
WARNING Read all safety warnings and
instructions. Failure to heed these markings
may result in personal injury and/or property
damage.
1. Study, understand, and follow all instructions before
operating this device.
2. Do not exceed rated capacity.
3. Use only on hard, level surfaces.
4. Lifting device only. Immediately after lifting, support the
vehicle with appropriate means.
5. Do not move or dolly the vehicle while on the jack.
6. Failure to heed these markings may result in personal
injury and/or property damage.
7. Lift only areas of the vehicle as specied by the vehicle
manufacturer.
8. No alterations shall be made to this product.
9. Never work on, under or around a load supported only
by this device.
10. Do not adjust safety valve.
11. Wear ANSI-approved safety goggles and heavy-duty
work gloves during use.
12. Keep clear of load while lifting and lowering.
13. Lower load slowly.
14. Apply parking brake and chock tires before lifting
vehicle.
15. Lift vehicle only at manufacturer recommended
locations.
16. Inspect before every use; do not use if parts are loose
or damaged.
17. Do not use for aircraft purposes.
18. The warnings, precautions, and instructions discussed
in this manual cannot cover all possible conditions
and situations that may occur. The operator must
understand that common sense and caution are
factors, which cannot be built into this product, but must
be supplied by the operator.
19. The brass components of this product contain lead,
a chemical known to the State of California to cause
cancer, birth defects (or other reproductive harm).
(California Health & Safety code § 25249.5, et seq.)
IMPORTANT! Before rst use:
Check hydraulic oil level and ll to 1/4" below the ll port
as needed as stated on page 3. Thoroughly test the Jack
for proper operation. If it does not work properly, bleed air
from its hydraulic system as stated on page 2.