Filter
Top Products
SKU 66187 For technical questions, please call 1-800-444-3353. Page 3
6. Insert Arm (6) into Frame (1) and secure with
Jam Bolt (D), as shown above.
Attach Ladder Stop (7) to Frame (1) using 7.
Carriage Bolt (M), Washer (N), and Nylon
Insert Nut (P).
Install Strap (8) through the bracket on the 8.
Frame (1).
Slide the assembled Frame (1) into the Front 9.
Base (4).
Rear Rack Installation
1. Slide Rear Mounting Bracket (3) over Rear
Base (5) as shown above. Temporarily se-
cure in place with Jam Bolt (D).
2.
below at the passenger side of the vehicle
near the tailgate. Loosen the Jam Bolt and
allow the Base to slide down so the foot rests
Mark the bedrail at center of the holes, 4 3.
holes in the side and 1 hole on the truck bed.
Any one of the holes in the Base can be
used for the truck bed hole. Set the assem-
bly aside.
Drill for and install 5 Blind Fasteners (H) in 4.
the locations marked in the previous step.
(Tailgate)
(Passenger
Side Bedrail)
(Bed)
5. Attach the assembly to the Blind Fasteners
as shown above using Bolts (E), Washers
(F), and Spring Washers (G) - as shown
above.