Harbor Freight Tools 66187 Automobile Accessories User Manual


 
SKU 66187 For technical questions, please call 1-800-444-3353. Page 2
INSTALLATION INSTRUCTIONS
Read the ENTIRE IMPORTANT
SAFETY INFORMATION section at the
beginning of this document including
all text under subheadings therein
before set up or use of this product.
Park truck in level, stable location well away 1.
-
tral and set parking brake.
Blind Fastener (H) Installation
Blind Fasteners will need to be installed
throughout these instructions. To install:
Slide Flat Washer (B) over 1.
Installation Bolt (A). Place a
box end wrench over Installa-
tion Nut (C), and thread Instal-
lation Nut into Installation Bolt
as shown to the right. Thread
Installation Nut completely
onto Installation Bolt. This as-
sembly is the installation tool.
WARNING! Verify that installation surface 2.
has no hidden brake lines, wiring, or other
critical components before drilling.
Drill an 11 mm (0.433”) hole in the location 3.
the Blind Fastener will be installed.
4.
on the lip of the hole.
Thread Installation Bolt into Blind Fastener 5.
as far as possible. Hold Installation Bolt in
place with one wrench while turning Installa-
tion Nut (C) clockwise with another wrench
until Blind Fastener is held securely in place.
Remove Installation Bolt from Blind Fastener.6.
Front Rack Installation
Note: The Front Rack is near the truck cab.
1. Slide Front Mounting Bracket (2) over Front
Base (4) as shown above. Temporarily se-
cure in place with Jam Bolt (D).
2.
below at the passenger side of the vehicle
near the cab. Loosen the Jam Bolt and allow

on the truck bed.
Mark the bedrail at center of the holes, 3 3.
holes in the side and 1 hole on the truck bed.
Any one of the 4 holes in the Base can be
used for the truck bed hole. Set the assem-
bly aside.
Drill for and install 4 Blind Fasteners (H) in 4.
the locations marked in the previous step.
(Truck
Cab)
(Front
Bedrail)
(Passenger
Side Bedrail)
(Bed)
5. Attach the assembly to the Blind Fasteners
as shown above using Bolts (E), Washers
(F), and Spring Washers (G) - as shown
above.
A
B
C