Harbor Freight Tools 3029 Automobile Accessories User Manual


 
OFF ROAD TRUCK LIGHT SYSTEM
Model 03029
3491 Mission Oaks Blvd., Camarillo, CA 93011
Visit our Web site at http//www.harborfreight.com
Copyright
©
2003 by Harbor Freight Tools
®
. All rights reserved. No portion of this
manual or any artwork contained herein may be reproduced in any shape or form
without the express written consent of Harbor Freight Tools.
For technical questions, please call 1-800-444-3353.
®
SAVE THIS INSTRUCTION MANUAL
You will need this Instruction Manual for the safety warnings and precautions, assembly/ inspec-
tion/maintenance information, and assembly diagram. Keep your invoice with this Instruction
Manual. Write the invoice number on the front page. Keep this Instruction Manual and invoice in
a safe and dry place for future reference.
GENERAL SAFETY WARNINGS AND PRECAUTIONS
1. Use eye protection. Wear ANSI approved safety impact eye goggles when assembling this product.
ANSI approved safety impact eye goggles are available from Harbor Freight Tools.
2. Use the right tool or attachment for the job. There are certain applications for which this product
was designed. Do not modify this product, and do not use this product for a purpose for which it was
not intended.
3. Replacement parts and accessories: When servicing, use only identical replacement parts. Only
use accessories intended for use with this product.
4. The Off Road Truck Light System is for OFF ROAD use only. Check with local and/or State
regulations regarding installation and use of this product on your vehicle.
5. WARNING! Vehicles equipped with airbags may have the sensors located inside the front bumper.
Make sure to consult the vehicle owner’s manual to determine the location of the airbag sensors. To
avoid damaging the sensors if they are located in the front bumper, do not drill holes in the bumper.
6. The 100 Watt Halogen Lamps become extremely hot under continuous use. Do not touch the
Lamps for at least 30 minutes after turning off the Lamps.
7. Turn off the Off Road Light System, disconnect its Power Cord from its 12 Volt DC Battery, and allow
its Halogen Lamps to completely cool down prior to performing any inspection, maintenance, or
cleaning on the unit.
8. WARNING! The warnings, precautions, and instructions discussed in this manual cannot cover all
possible conditions and situations that may occur. The operator must understand that common sense
and caution are factors which cannot be built into this product, but must be supplied by the operator.
MANUAL REV 04/05