GE WSM2700/80D Automobile Accessories User Manual


  Open as PDF
of 3
 
GE Appliances
WSM2700/80D – GE
®
27” Unitized Spacemaker
®
Washer and Dryer
Specification Created 6/03
Dimensions (in inches)
Vent
(rear
only)
9-3/8
75-1/2
54-5/16
29-7/16
41-1/4
43
5-1/4
3-3/4
Drain outlet
(rear)
Water inlets
(rear)
Gas supply
pipe (rear)
27
36-1/16
51
o
11-7/16
16-1/4
25-1/4
2-1/2
4-13/16
30-13/16
47
Electrical Requirements:
WSM2700D Electric Dryer – This appliance should be connected to an individual,
properly-grounded branch circuit with 120/240V or 120/208V single-phase 60 Hz
electrical service and should be protected by 30-amp time-delay fuses or circuit
breakers. This appliance is manufactured with neutral connected to the frame.
Power cord should be purchased separately.
Note:
These appliances are not approved for 120-volt operation.
Gas Requirements:
WSM2780D Gas Dryer – This appliance should be connected to an individual branch
circuit with 120-volt single-phase 60 Hz electrical service and should be protected
by 20-amp time-day fuses or circuit breakers. This appliance is equipped with a
4-foot long flexible U.S. listed 20-amp power cord to match a 20-amp receptacle.
Note:
Gas Rated input 20,000 BTU/HR. Factory equipped for natural gas. Tested for LP
gas.
LP gas supply requires a conversion kit. Have a qualified gas technician
install a conversion kit before use.
Exhaust Information:
Exhausting the dryer to the outside is strongly recommended to prevent large amounts
of moisture and lint from being blown into the room. Closet installations
must be
exhausted to the outside.
Installation Information:
For complete information, see installation instructions packed with the product.
Power Cord Location
Back View
Power
Cord Hole
41''
12-1/2''
R
Listed by
Underwriters
Laboratories
For answers to your Monogram,
®
GE Profile
™
or
GE
®
appliance questions, visit our website at
GEAppliances.com or call
GE Answer Center
®
service, 800.626.2000.
next