Filter
Top Products
3
OPERATION•SETTINGS
3
OPERATION•SETTINGS
11
10
Auto Mute Mode
Auto Mute will automatically reduce the
audio volume of all alerts after 4 seconds
for as long as the signal is detected. When
you turn Auto Mute on or off while in Voice
Alert™ mode, you will hear “Auto Mute on"
or “Auto Mute off.” In Tone mode, you will
hear 2 beeps for Auto Mute on and 1 beep
for Auto Mute off. (See page 7 for
instructions on using the Program mode
to select Auto Mute.)
The factory setting for Auto Mute is ON.
Muting an Alert
Your ESD-9860 allows you to quickly
turn off an audio alert by momentarily
pressing and releasing the PROG/MUTE
button. If you press and release the
PROG/MUTE button a second time
during the alert, the audio alert will be
turned back on.
Voice/Tone Setting
You can set your ESD-9860 to sound
alerts and confirm user settings with
either a voice or a tone. When you
turn Voice Alert™ on, you will hear
“Voice Alert.” When you turn Tone Alert
on, you will hear “Tone Alert” and
subsequent voice alerts will be turned
off. (See page 7 for instructions on
changing the Voice/Tone setting.)
The factory setting is Voice Alert™ mode.
Auxiliary Audio Jack
Use to connect an external speaker in
environments with high ambient noise
levels. The internal speaker will be
disconnected.
PROG/MUTE button
Press and release
Setting the SmartMute
™
Activation Point
Your ESD-9860 must be installed in
your vehicle.
Caution: Do not attempt to set the rev
point while driving. Your vehicle should
be parked and idling.
SmartMute™ must be turned on.
1.
3.
2.
Procedure
In Program mode, go to Set
SmartMute. Press and release the
SET/CITY button to begin
setting SmartMute™.
4.
Procedure
Press and release either the
SELECT/DIM button to proceed
to the next user mode or the
PROG/MUTE button to exit the
Program mode.
Voice
none
Visual Display
none
Tone
none
Procedure
Rev your engine to the level you
wish to set. Rev the engine
slightly above idle and hold revs
steady for 2 seconds.
Voice
none
Visual Display
none
Tone
none
NOTE: If the unit is unable to sense
usable pulses within three seconds,
SmartMute™ will indicate an error and
automatically turn off.
Procedure
At the desired rev level,
press and release the
SET/CITY button.
Voice
“smart mute
set”
Visual Display
Smart
then
SET!
Tone
3 beeps
“smart mute
error”
followed by
“smart mute off”
Error
SmartOff
1 beep
“smart mute
error”
followed by
“smart mute off”
Error
SmartOff
1 beep
NOTE: If you do not set a rev point
within 20 seconds of beginning these
steps, SmartMute™ will indicate an
error and automatically turn off.
Press SET again...
Error
Smart
SET!
SmartOff
Voice
“set engine
revs”
Visual Display
Press SET again at
desired RPMs...
Tone
2 beeps
Error
SmartOff