Filter
Top Products
58 nüvi 3400 Series Owner’s Manual
Changing the Fuse in the Vehicle
Power Cable
When replacing the fuse, do not lose any of the
small pieces and make sure they are put back in
the proper position. The vehicle power cable
does not work unless it is assembled correctly.
If your device does not charge in your vehicle,
you may need to replace the fuse located at the
tip of the vehicle adapter.
1
Unscrew the end piece ➊.
TIP: You may need to use a coin to remove
the end piece.
2
Remove the end piece, the silver tip
➋, and the fuse (glass and silver
cylinder)
➌.
3
Install an 2 A fast-blow fuse.
4
Place the silver tip in the end piece.
5
Screw the end piece back into the vehicle
power cable.
Mounting on Your Dashboard
The permanent mounting adhesive is extremely
difcult to remove after it is installed.
Use the enclosed mounting disk to mount your
device to the dashboard and comply with certain
state regulations.
1
Clean and dry the dashboard where you are
placing the disk.
2
Remove the backing from the adhesive on
the bottom of the disk.
3
Place the disk on the dashboard.
4
Remove the clear plastic cover from the top
of the disk.
5
Place the suction cup mount on top of the
disk.
➊
➋
➌