Fisher-Price 78475 Motorized Toy Car User Manual


 
Assembly
F
1
Fit the cover plate over the opening above the louvers in
the front of the vehicle body.
Insert two # 8 x
1
/2" screws through the cover plate and
into the vehicle body.
Tighten the screws with a Phillips screwdriver. Do not
over-tighten.
Cover Plate
Vehicle
Body
Fit a hubcap on the rear axle and slide it into the center
of the rear wheel.
Position the vehicle body upside down. Make sure that
the tabs on the gearboxes rest against the rear axle
support bars so the gearboxes and motors do not
hang down.
Slide two
7
/
16
" washers onto one of the rear axles.
Slide a rear wheel, driver side first, onto the rear axle.
Fit the teeth on the gearbox into the notches in the driver.
7
/
16
" Washers
Tabs
Rear Axle
Support Bar
Rear Wheel
Rear Axle
Gearbox
Driver
Teeth
Rear Axle
Hubcap
2
3
4
Slide a hex bushing onto the rear axle. The ring side of
the hex bushing should face out.
Press firmly to fit all but the ring on the end of the hex
bushing into the rear wheel.
Hex
Bushing
Rear Axle
Ring Side
9
Louvers