Fisher-Price 78475 Motorized Toy Car User Manual


 
Battery Installation
Important Note: Use only a Power Wheels
®
6 volt battery
with an A-style connector and built-in thermal fuse. Use of
any other battery may damage your vehicle. Make sure that
you charge the battery for at least 18 hours using the
enclosed Power Wheels
®
Super 6
Volt charger with A-style
connector before operating your vehicle for the first time.
Charge the battery for at least 14 hours after each use of
the vehicle. Never charge the battery longer than 30 hours.
Failure to follow these instructions may damage your battery
and will void your warranty.
1
H
Press in on each side of the seat (near each tab) and lift
the front of the seat.
Remove the seat.
Place the battery upright in the battery compartment.
Plug the battery and motor harness connectors together.
Push firmly to plug the two connectors together.
Lower the battery retainer over the batteries.
Fit the carriage bolt up through the hole in the underside
of the vehicle body and through the end loop in the
battery retainer.
Fit the #10 washer onto the carriage bolt.
Fit the wing nut onto the carriage bolt.
Tighten the wing nut. Do not over-tighten.
Insert the ends of the battery retainer into the holes in the
front of the battery compartment.
Fit the hooked tabs on the back of the seat into the slots
in the back of the vehicle body.
Press in on the sides of the seat and lower the seat
to insert the tabs on each side of the seat into the
vehicle body.
Vehicle
Body
Seat
Battery
Connector
Motor Harness
Connector
Battery
Holes
Battery Retainer
Carriage Bolt
Wing Nut
#10 Washer
Battery Retainer
2
3
5
4
16
PUSH HERE
Tabs
Seat
Vehicle Body
PUSH HERE