Filter
Top Products
TM
11
Assembly
• Press the tab under the back of the seat and lift to
remove the seat.
• Fit the rectangular opening in the cowling over the
shifter handle.
• Align the front, side and rear tabs on the cowling with
the slots in the vehicle body but do not snap the tabs
into the slots.
• Make sure the harness wires are positioned in the
vehicle body channel to prevent them from being
pinched between the cowling and vehicle body.
T
M
7
Cowling
Shifter
Handle
Side
Tabs
Side
Tabs
Rear Tab
Harness Wires
Front Tabs
Front Tabs
Channel
PRESS COWLING HERE
To Snap Front Tabs
PULL VEHICLE
BODY UP HERE
To Snap Front Tabs
6
• Press firmly on the front of the cowling to snap the four
front tabs into the slots in the vehicle body. Make sure
the side and rear tabs stay aligned with the slots.
Note: Pull up on the front of the vehicle body while
pressing down on the cowling to make sure the front
tabs snap into the slots.
• Press firmly on the back of the cowling to snap the rear
tab into the slots in the vehicle body.
T
M
8
9
PRESS HERE
To Snap Side Tabs
PRESS HERE
To Snap Rear Tab
• Press firmly on each side of the cowling to snap the
four side tabs into the slots in the vehicle body. Make
sure the rear tab stays aligned with the slots.