Filter
Top Products
®
• Plug the charger into a standard 120 volt wall outlet.
Note: If power flow to the wall outlet is controlled by a
switch, make sure the switch is “ON”.
• Before first-time use, charge the battery for at
least 18 hours. Never charge the battery longer than
30 hours.
• Recharge the battery for at least 14 hours after each
use of your vehicle. Do not charge the battery longer
than 30 hours.
• Once the battery is charged, disconnect the charger
connector from the battery connector. Unplug the
charger from the wall outlet. The battery is now charged
and is ready to be installed in your vehicle. Please see
“Battery Installation” on page 16 for detailed instructions
on installing your battery.
• If you are charging the battery for the first time, insert a
25 amp fuse into the battery.
Note: The top of the fuse will not be flush with the top of
the battery when properly installed.
• If you are recharging your battery, make sure the 25 amp
fuse already installed in the battery is in good condition.
Remove the fuse from the battery and look at it to make
sure it is not blown. Replace a blown fuse with a new
Power Wheels
®
25 amp fuse.
IMPORTANT
A 25 AMP
FUSE M
UST
BE INSTALLE
D IN TOP
OF BATTE
RY BEFORE
TOY WILL RECHARGE
OR OPERATE
®
25 Amp Fuse
1
3
®
Battery Connector
Charger
Connector
2
• Squeeze the connector tabs on the charger connector
and plug it into the battery connector.
IMPORTANT! If you are recharging your battery, you
will need to remove the battery clamp (engine cover)
and disconnect the battery connector and motor
harness connector.
GOOD FUSE
"BLOWN" FUSE
Battery Charging
8