Filter
Top Products
Assembly
6
5
13
Microphone
Dash
• Bend the plastic tip on the end of the microphone cord so
that it forms a “T”.
• Fit the “T” end of the microphone cord down through
the hole in the dash pocket. Pull up gently on the
microphone cord to make sure the end is secured in
the dash.
• To hang the microphone on the dash, fit the hook on the
back of the microphone onto the notch in the dash.
• Before applying labels to the dash, wipe the dash with a
clean dry cloth to make sure it is free of dirt and oils.
Make sure your hands are clean and dry.
• Apply labels as shown in the illustration. For best results,
avoid repositioning a label once it has been applied.
PLAY
STOP REV FWD
PAUSE
COMPACT DISC
TREB
BASS
COOL
HEAT
CAUTION
This vehicle was
designed to
carry 130 lbs.
or less.
Overloading
may cause
extensive
damage to
motors, gears
and tires.
9276
HI
LO KC
7
20
12
25
18
17
8
21
10
16
9
Dash View
Battery Tips:
• Do not mix old and new batteries.
• Do not mix different types of batteries: alkaline, standard
(carbon-zinc) or rechargeable (nickel-cadmium).
• Remove the batteries during long periods of non-use.
Always remove exhausted batteries from the sound box.
Battery leakage and corrosion can damage the vehicle.
• Never short circuit the battery terminals.
• Non-rechargeable batteries are not to be recharged.
• Only batteries of the same or equivalent type as
recommended in these instructions are to be used.
• If removable rechargeable batteries are used, they are
only to be charged under adult supervision.
• Rechargeable batteries are to be removed from the
sound box before they are charged.
• If you use a battery charger, it should be examined
regularly for damage to the cord, plug, enclosure and
other parts. Do not use a damaged battery charger until
it has been properly repaired.
• When sound from the vehicle becomes faint, or if the
sound stops working, it’s time to replace the batteries.
• Dispose of batteries safely.
• Loosen the screw in the sound box’s battery
compartment door using a Phillips screwdriver and open
the battery compartment.
• Insert three, size “AA” (LR6) alkaline batteries in the
sound box as indicated in the battery compartment.
• Close the battery compartment door and tighten the
screw using a Phillips screwdriver. Do not over-tighten.
(For longest life, use only alkaline batteries.)
Sound Box
Battery
Compartment
Battery
Compartment
Door
7
SHOWN ACTUAL SIZE
3 x 1.5V
“AA” (LR6)