Fisher-Price 74020 Motorized Toy Car User Manual


 
Children can be harmed by small parts,
sharp edges and sharp points in the
vehicle’s unassembled state, or by electrical
items. Care should be taken in unpacking
and assembly of the vehicle. Children
should not handle parts, including the
battery, or help in assembly of the vehicle.
WARNING
Assembly
F
IMPORTANT NOTE! Assemble the battery retainer unit
to the dash of your vehicle before beginning assembly
of your vehicle.The battery retainer unit must be
assembled to the dash before assembling the dash to
the vehicle body.
1
Battery
Clamp
Unit
Dash
• Position the dash upside down.
• Fit the battery clamp unit into the underside of the
dash so that the clamp fits into the grooves in the dash.
Make sure the battery clamp unit is flush against the
surface of the dash.
Clamp
Grooves
Battery Charging
9
Plug the charger connector into the battery .
Plug the charger into a standard 120 volt wall outlet .
Note: If power flow to the wall outlet is controlled by a
switch, make sure the switch is “ON”.
Before first-time use, charge the battery for at least 18
hours. Never charge the battery longer than 30 hours.
Recharge the battery for at least 14 hours after each
use of your vehicle. Do not charge the battery longer
than 30 hours.
Once the battery is charged, pull firmly on the charger
connector to disconnect it from the battery. Unplug the
charger from the wall outlet. The battery is now ready to
be installed in your vehicle. Please see the Battery
Installation section on page 19 for detailed instructions on
installing your battery. If your battery is already installed in
your vehicle, simply re-connect the motor harness
connector to the battery and lower and fasten the hood.
Battery
Charger
Connector