Filter
Top Products
Sport Bar
KC
TM
Light Rack -
Front Half
• Position the sport bar with the ends on a flat surface,
as shown.
• Fit and hold the front and back halves of the KC
TM
light
rack against the sport bar. Make sure the two KC
TM
light
rack halves are aligned, and that the screw holes in the
KC
TM
light rack are aligned with the screw holes in the
sport bar.
• Snap the tabs on the front half of the KC
TM
light rack into
the slots below the light housings on the rear half of the
KC
TM
light rack.
• Insert two #6 x1
1
/
2
" screws through the holes in the back
of the KC
TM
light rack, through the sport bar, and into the
front half of the KC
TM
light rack.
• Tighten the screws with a Phillips screwdriver.
Do not over-tighten.
KC
TM
Light Rack - Back Half
Tabs
25
Assembly
• Align the four tabs on the inside of a light cover
with the four slots in one of the light housings on the
KC
TM
light rack. (Make sure the light covers are
positioned with the wide spaced tabs at the top.)
• Push firmly on the light cover to snap it to the housing.
• Repeat this procedure on the other side of the
KC
TM
light rack to assemble the other light.
Light Covers
Housing
Slots
26
16
#6 x 1
1
/
2
"
Screws
27
• Fit the sport bar and sport bar support legs into the holes
in the vehicle body.
• Push down firmly on a sport bar side leg while pulling
up on the side fender to fit the sport bar into the
vehicle body.
• Repeat this procedure on the other side of the
vehicle body.
Sport Bar
Side
Fender
PULL HERE
PUSH
HERE