EverFocus ez-platecam-002 Automobile Electronics User Manual


 
1. Cautions
3
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions;
1. This device may not cause harmful interference.
2. This device must accept any interference received, including
interference that may cause undesired operation.
Note -
This equipment has been tested and found to comply with the limits
for a Class A digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with
the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area
is likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.
WARNING -
This is a class A product. In a domestic environment this product may
cause radio interference in which case the user may be required to take
adequate measures.
Caution -
Any changes or modifications in construction of this device which are
not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
1. If DC power is used a regulated DC12V 1A power supply is recommended for use
with this camera for the best picture and the most stable operation.
An unregulated power supply can cause damage to the camera.
If an unregulated power supply is used, product warranty will be void.
2. It is recommended that the camera is used with a monitor or other equipment that
has a CCTV quality 75 video impedance level.
3. Do not attempt to disassemble the camera to gain access to the internal
components. Refer servicing to the manufacturer.
4. Never face the camera towards the sun, any bright, or re ective light that may
cause smear on the picture or cause possible damage to the CCD.
5. Do not remove the serial number sticker.