Filter
Top Products
INSTRUCTION SUPPLEMENT FOR 2003-
LATER POLARIS PREDATOR
Removing stock carburetor and cables.
1. Remove seat and gas tank. Make sure fuel
petcock is in “off” position.
2. Remove throttle cable paying close attention
to routing, as the new cable(s) will need too
be routed the same.
3. Remove stock carburetor and stock throttle
housing. Stuff a clean, dry rag into manifold
to keep debris out of motor.
Twist Throttle Instructions
1. Install the throttle cables into the supplied
throttle housing and place onto clean
handlebar end.
2. Route throttle cables through frame as stock
cable was routed.
3. Install the pull cable into the 4:00 position
and the return cable end into the 1:00
position of the cable wheel. Secure cables
to cable bracket by replacing end piece and
Phillips screw. See figure 2.
NOTE: SEE FIGURE 1 TO IDENTIFY CABLES.
The bottom cable is the pull cable.
Figure1.
Figure 2.
Thumb Throttle Instructions
NOTE: #3196 KIT REQUIRES THE USE OF
A SUZUKI THUMB THROTTLE HOUSING.
PART #57100-07G00 CAN BE ORDERED
FROM ANY SUZUKI DEALER.
1. Thread new throttle cable into housing and
insert cable end into throttle lever.
2. Install cable into cable wheel on carburetor
in the 4:00 position and secure cable into
lower slot on cable bracket by replacing end
piece and Phillips screw. See figure 6.
Carburetor installation