Filter
Top Products
PostScript Picture
(Edelbrock B/W Logo.eps)
FUEL PRESSURE REGULATOR PLATE KIT
Catalog #8192
Catalog #8193
Catalog #8195
INSTALLATION INSTRUCTIONS
FUEL PRESSURE REGULATOR PLATE KITS
Catalog # 8192: Standard-flange dual-inlet Holley carburetors (gasoline only)
Pressure range 4-1/2 to 9 P.S.I. (preset to 7 P.S.I.)
Catalog # 8193: 4500 Series dual-inlet Holley carburetors (gasoline only)
Pressure range 4-1/2 to 9 P.S.I. (preset to 7 P.S.I.)
Catalog # 8195: Standard-flange dual-inlet Holley carburetors with GM throttle cable bracket (gasoline only)
Pressure range 4-1/2 to 9 P.S.I. (preset to 7 P.S.I.)
1. Fuel inlet and outlet ports are marked on
regulator.
2. Fuel line has provision for fuel pressure
gauge (1/8" pipe).
3. Fuel inlet port accepts AN fitting supplied
for #8 fuel Line.
4. Fuel pressure is adjusted by loosening
5/8" lock-nut “A” on top of regulator and
with 7/32" Allen key, turn set screw “B”
to desired setting.
5. Re-tighten lock nut.
Caution: Do not over-tighten fittings in
pressure regulator. Fittings which go with
pipe threads tend to crack parts when over-
tightened. Use a good pipe sealant to create
a proper seal. (Pipe tape is not
recommended for this application). Care
must be taken when installing two self-
tapping 1/4-20 support bolts in regulator.
We suggest tapping threads prior to
installation, (“C”). Upon engine start-up,
check all fittings and hoses for possible fuel
leaks. Adjust pressure to desired settings.
PLEASE study these instructions carefully before installing your new fuel pressure regulator plate kit. If you have any
questions or problems, do not hesitate to call our Technical Hotline at: 800-416-8628, 7 am - 5 pm, Monday-Friday, Pacific
Standard Time or e-mail us at edelbrock@edelbrock.com.
Brochure #63-0059
© 2001 Edelbrock Corporation
Page 1
Rev. 12/01
A
B
C
#8192 Shown