Filter
Top Products
Catalog #15016
Rev. 5/05
©2005 Edelbrock Corporation
Brochure #63-0396
TURBOCHARGER TO OUTLET ELBOW GASKET
(For Turbocharger Kit #1500, 1501, 1502, 1503, 1504)
Catalog #15016
INSTALLATION INSTRUCTIONS
PLEASE study these instructions carefully before beginning this installation. If you have any questions or problems, do not hesitate
to contact our Technical Hotline at: 1-800-416-8628, from 7am-5pm, Monday-Friday, Pacific Standard Time or via e-mail at:
Edelbrock@Edelbrock.com.
DESCRIPTION: Stainless steel gasket used to seal the turbocharger turbine outlet. It can also be used with any Garrett T25 or T28
Turbocharger.
INSTALLATION
Edelbrock Corporation • 2700 California St. • Torrance, CA 90503
Tech Line: 1-800-416-8628 • E-Mail: Edelbrock@Edelbrock.com
1. When attaching the exhaust outlet elbow to the turbocharger turbine outlet, tighten the nuts in a criss-cross pattern. This will
evenly compress the gasket. Tighten the nuts in a few increments until the gasket is fully compressed.
2. Torque the 8mm x 1.25 nuts to 190 inch/lbs. (approximately 16 ft/lbs).
Catalog #15016
Rev. 5/05
©2005 Edelbrock Corporation
Brochure #63-0396
TURBOCHARGER TO OUTLET ELBOW GASKET
(For Turbocharger Kit #1500, 1501, 1502, 1503, 1504)
Catalog #15016
INSTALLATION INSTRUCTIONS
PLEASE study these instructions carefully before beginning this installation. If you have any questions or problems, do not hesitate
to contact our Technical Hotline at: 1-800-416-8628, from 7am-5pm, Monday-Friday, Pacific Standard Time or via e-mail at:
Edelbrock@Edelbrock.com.
DESCRIPTION: Stainless steel gasket used to seal the turbocharger turbine outlet. It can also be used with any Garrett T25 or T28
Turbocharger.
INSTALLATION
Edelbrock Corporation • 2700 California St. • Torrance, CA 90503
Tech Line: 1-800-416-8628 • E-Mail: Edelbrock@Edelbrock.com
1. When attaching the exhaust outlet elbow to the turbocharger turbine outlet, tighten the nuts in a criss-cross pattern. This will
evenly compress the gasket. Tighten the nuts in a few increments until the gasket is fully compressed.
2. Torque the 8mm x 1.25 nuts to 190 inch/lbs. (approximately 16 ft/lbs).