Dukane DK100 Radar Detector User Manual


 
03-TM-0037 REV 13
Page 20 of 24
Figure 20. Beacon Exploded View Showing Relative Location of Battery
and Related Parts
WARNING
REPLACE BATTERY WITH AUTHO-
RIZED REPLACEMENT PARTS
ONLY. USE OF AN UNAUTHO-
RIZED BATTERY WILL VOID THE
WARRANTY AND MAY CAUSE AN
INOPERATIVE OR DANGEROUS
CONDITION. USE OF AN UNAU-
THORIZED BATTERY MAY
PRESENT A RISK OF FIRE OR
EXPLOSION. SEE FIGURE 19 PAGE
18 FOR REPLACEMENT BATTERY
KIT.
CAUTION
DO NOT RECHARGE, DISAS-
SEMBLE, HEAT ABOVE 160°F (71°C)
OR INCINERATE. DISPOSE OF THE
BATTERIES PROMPTLY (IN AC-
CORDANCE WITH ALL LOCAL
STATE AND FEDERAL REQUIRE-
MENTS), KEEP AWAY FROM CHIL-
DREN. THERE IS A RISK OF BAT-
TERY FIRE, EXPLOSION, AND
BURNS.
J. Perform OFF-CURRENT TEST as outlined in
Section 6.7.
K. Position rubber shock cushion around contact
spring and on the inside of the battery cover.
L. Replace the cover and tighten it until the
cover flange contacts the body or leaves less than
a 0.003 inch gap. Use hand force only on the
wrench. Hold the beacon in a vise clamp as
shown in Figure 18. Clean the beacon exterior of
excess O-ring grease.
M. Perform operational test of beacon as out-
lined in Section IV.
N. Replace the battery replacement date label on
the outside of the beacon case with the new label
supplied with the battery. Locate the label on the
beacon body in the space provided as shown in
Figure 21. Never put label on the water switch
end of the beacon. Place the new label on the
beacon after the beacon is installed in the mount.