Filter
Top Products
8
AUTOMATIC LOCK
/UNLOCK
Programmable as Active or Inactive during installation.
This function locks the doors when ignition key is in RUN position, engine is running and brakes are applied. Doors are
unlocked when key is turned from RUN to OFF or when Continuous Mode is activated.
If “Unlock“ function is set to unlock only driver's door on the first command, the “Automatic Unlock“ function will unlock
driver's door only. If dome light is connected to system, it is activated when an automatic unlock occurs.
This function is : Active
Inactive
.
TRUNK RELEASE
/ ACCESSORY ACTIVATION
Press the and buttons simultaneously (lights: 3). According to what is connected to the system; the trunk is released
or the accessory is activated
,
the parking lights flash three times to confirm command has been received.
The command cannot be executed if ignition key is in RUN position. In this case, parking lights flash once to confirm that
command has been received but could not be executed.
If you are not sure you have received confirmation, repeat command. System will repeat confirmation as often as you wish.
If your vehicle is equipped with a factory installed security system and that this system is neutralized by the trunk release
command, remember to rearm it after trunk is closed ("Lock" command).
UTILITY COMMAND
This command allow you to control one of the vehicle’s accessory depending on what was connected during installation
(headlights, defroster, etc.). For more information, check with your technician.
To activate this function, simultaneously press the
and buttons.
The accessory associated to this command is activated for the duration set at time of installation.
The delay can be canceled by repeating the command.
When accessory is deactivated after the delay has expired, the parking lights blink once then the remote control sends a
confirmation.
ANTITHEFT (CIRCUIT DISABLER)
Programmable as Active
or Inactive
during installation.
Your Remote Starter is equipped with an antitheft system. This system, when enabled, consists of an output that controls a
relay that cuts all circuits required to operate your vehicle (optional connection).
There are two types of antitheft systems.
‘PASSIVE ARMING’ TYPE ANTITHEFT
This type of antitheft system arms automatically when ignition key is turned from ‘RUN’ to ‘OFF’ and remains ‘OFF’ for one
minute. It can also be armed manually by sending a ‘Lock’ command (unless ignition key is in ‘RUN’ position).
DISARMING
Antitheft system is disarmed for one minute when you send an ‘Unlock’ command.
If ignition key is not turned to ‘RUN’ position within one minute, system automatically rearms, thus preventing an intruder
from starting your vehicle, even with ignition key. The indicator light (optional) blinks rapidly during rearming, and then
continuously when antitheft system is armed.
It can be connected so that horn sounds if an intruder tries to start your vehicle when antitheft is armed.
‘ACTIVE’ TYPE ANTITHEFT
This type of antitheft system is armed by sending a ‘Lock’ command (unless ignition key is in ‘RUN’ position) and is
disarmed by sending an ‘Unlock’ command. The indicator light (optional) blinks continuously when antitheft system is armed
(if the AstroStart security system is not armed) .
PANIC
Panic mode is used to attract attention if you are in difficulties.
This command will not be executed if engine is kept running by ignition key. Use the stop command to abort panic mode or
depress brake pedal.
Press and hold the
or button for at least 4 seconds. This command activates parking lights, horn, and dome light,
depending on which is connected to system, for 30 seconds.