Filter
Top Products
only with lock/unlock buttons. If an anti-grind/starter kill relay is installed on a vehicle without power door locks, the
lock and unlock buttons on the remote control still have to be utilized to operate the Anti-grind/starter kill.
REMOTE TRUNK RELEASE:
This feature, if installed, will remotely release a factory electronic trunk through the transmitter. This feature may
require extra labor and/or parts to install
1) To operate, press (#3) trunk release button for at least one second to remotely open trunk.
VALET MODE/ STARTER KILL OVERRIDE
The keyless entry will still function normally while in valet mode. In the event of a lost or broken transmitter, the
Starter Disable/Anti-grind must be overridden in order to start the vehicle with the key.
1) With the key in the ON position, press and hold Program/Valet switch for 6 seconds. LED will turn on solid if
installed and the system is now in valet. Perform this procedure again to get out of Valet mode.
HOOD OPEN SAFETY SWITCH
Prevents the engine being Remote Started when hood is open and will abort a remote start if running. Eliminates
risk of injury to someone working under the hood of the vehicle. If a Remote Start is requested with the hood open,
the lights will flash twice, Ignition will not turn on, and the unit will not attempt a start.
BRAKE PEDAL RESET CIRCUITRY
Prevents starting or shuts off a remote started vehicle when this circuit is active or activated. Prevents unauthorized
tampering. This circuit shuts the system down immediately when brake pedal is pressed if key is not in ignition and
turned to the run position.
OEM ALARM INTERFACE
This feature is designed to Arm, Re-arm, or Disarm factory equipped security systems in conjunction with remote
start and keyless entry (if needed). This feature will maintain the original integrity and security of your vehicle’s
factory equipped systems before, during, or after an aborted remote start.
ANTI-GRIND / STARTER DISABLE
Prevents User from accidentally grinding the starter if the Ignition key is turned too far to the start position while
engine is already running from the remote starter. Starter circuit is automatically disabled when doors are locked
using remote as an added security feature.
SERVICING / JUMP STARTING
Be sure to put your CoolStart™ in Valet mode before having your vehicle serviced. If you have an alarm system to
control your CoolStart™ (RS901), be sure to have it in valet as well. As an alternative, the Main Alarm / Remote
Starter Power Fuse(s) may need to be removed before service. This will help prevent service personnel from