Filter
Top Products
14
CONVENIENCE AND SAFETY FEATURES
VALET MODE / STARTER DISABLE OVERRIDE
Before servicing your vehicle or handing the keys over to a Valet we recommend putting the unit into valet mode.
The remote start function WILL NOT operate when in Valet mode. To enter Valet mode, turn the key to the ON
position, press and hold Program/Valet switch for 5-6 seconds. The LED will turn on solid and the system is now in
valet. Perform this procedure again to exit of Valet mode. The keyless entry will still function normally while in valet
mode. In the event of a lost or broken transmitter, perform this step to override the Starter Disable (if installed).
ANTI-GRIND / STARTER DISABLE (Optional, relay not included)
This Optional feature prevents the user from accidentally grinding the starter if the Ignition key is turned too far to the start position
while engine is already running from the remote starter. The Anti-Grind/Starter Disable requires the use of an external relay. This
system must be programmed to allow the relay to work as a starter disable.
PASSIVE STARTER DISABLE (Optional)
This EZEE START system includes a programmable feature to allow the Optional Starter Disable to activate
automatically 1 minute after the ignition is turned off. This programmable feature may provide insurance discounts
for “Passive Security” functions, or meet an insurance requirement in your province (CAN).
HOOD OPEN SAFETY (Requires grounding hood pin installation)
Prevents the engine from being Remote Started when hood is open and will shut OFF the engine if opened during
while remote started. Eliminates risk of injury to someone working under the hood of the vehicle with a properly
working hood pin installed. If Remote Start button is pressed with the hood open, the lights will flash once and the
unit will not attempt a start.
BRAKE PEDAL RESET
Prevents starting or shuts off a remote started vehicle when this circuit is active or activated. Prevents unauthorized tampering. This
circuit shuts the system down immediately when brake pedal is pressed if the key is not in ignition and turned to the ON position.
OEM ALARM INTERFACE
This feature is designed to Disarm and Re-arm Factory equipped security systems in conjunction with remote start and keyless entry
(if needed for your vehicle). This feature will maintain the original integrity and security of your vehicle’s factory equipped systems
before, during, or after remote start.
NOTE:
When changing, charging, or jumpstarting the vehicle’s battery we recommend removing the main power fuses
located on the heavy gauge RED wires near the remote start module.