Filter
Top Products
12
TRANSMITTER PROGRAMMING
Note: All transmitter codes must be learned at time of programming!! The RS-1 learns up to 4 different
transmitter codes.
1. Turn key to the ON position. (Pink wire must be connected.)
2. Press Programming button 4 times, then after a few seconds the unit flashes the parking lights 4 times.
3. Press button #1 of the transmitter to be coded. You should get 2 light flashes indicating the unit is waiting for a
2
nd
code, then press button #1 of a second transmitter, the unit will flash 3 times indicating its waiting for the 3
rd
code and so on. If all 4 codes are learned, the unit will automatically exit code learning mode, otherwise turn key
off. See diagram below.
IGN
OFF
WAIT FOR
4 FLASHES
PRESS 4X's
FLASH 2, 3, or 4 X's
IGN
OFF
PRESS START BUTTON