Filter
Top Products
11
CONVENIENCE AND SAFETY FEATURES
VALET MODE (Requires Installation of Valet Switch)
Before servicing your vehicle or handing the keys over to a Valet we recommend putting the unit into Valet Mode.
The remote start function WILL NOT operate when in Valet Mode. To enter Valet mode, turn the key to the ON
position, press and hold Program/Valet switch for 5-6 seconds. The LED will turn on solid when the system is in
Valet Mode. To exit Valet Mode, perform this procedure again. The keyless entry will still function normally while in
Valet Mode. In the event of a lost or broken transmitter, perform this step to override the Starter Disable (if
installed).
ANTI-GRIND / STARTER DISABLE (Optional, relay not included)
This Optional feature prevents the user from accidentally grinding the starter if the Ignition key is turned too far to
the start position while engine is already running from the remote starter. The Anti-Grind/Starter Disable requires
the use of an external relay.
HOOD OPEN SAFETY (Requires hood pin switch)
Prevents the engine from being Remote Started when hood is open. Eliminates risk of injury to someone working
under the hood of the vehicle with a properly working hood pin installed. The hood can be opened after a
successful Remote Start, but not before. If Remote Start button is pressed with the hood open, the lights will flash
once and the unit will not attempt a start.
BRAKE PEDAL RESET
Prevents starting or shuts off a remote started vehicle when this circuit is active. Prevents unauthorized driving of
vehicle. This circuit shuts the system down immediately when brake pedal is pressed. Turn the ignition key to the
“ON” position before the brake pedal is pressed.
OEM ALARM INTERFACE (May require optional Databus Module)
This feature is designed to Disarm and Re-arm Factory equipped security systems in conjunction with remote start
and keyless entry (if needed for your vehicle). This feature will maintain the original integrity and security of your
vehicle’s factory equipped systems before, during, or after remote start. Some vehicles require an optional Databus
module to operate a factory alarm or keyless entry.
NOTE: When changing, charging, or jumpstarting the vehicle’s battery we recommend removing the main power
fuses located on the heavy gauge RED wires near the remote start module.