Filter
Top Products
CARJACK PROTECTION
PROGRAMMABLE PASSIVE CARJACK
This feature provides Passive Carjack protection and must be enabled before use through Alarm programming
options #7 & #12 on page 13. We recommend this mode should only be used in serious situations. When the
Ignition is on (vehicle is running), and a door is opened, then closed, the Carjack countdown sequence will
automatically be initiated. 60 Seconds later, the unit will begin a Carjack Cycle consisting of 20 seconds of pre-
warning chirps turning into a full system activation with siren/flashing light pulses for up to 5 min. To reset Passive
Carjack, IGNITION MUST BE ON, then press and hold the override button at least 5 seconds (or until flashing LED
shuts off).
SWITCH-CONTROLLED CARJACK PROTECTION (PINK WIRE CONFIGURATION)
NOTE: Carjack protection features using a switch on the PINK wire, operate independently of programmable
protection methods listed above
Pink wire must be connected to a hidden toggle or momentary switch providing +12V. This configuration will enable
the vehicle owner to activate a Carjack countdown by pressing a designated toggle switch or hidden button (not
included with kit) during a Carjack situation. A Carjack countdown will begin under the following conditions: Ignition
is ON (vehicle is running), the button or toggle switch is pressed FIRST, and a door opens & closes. Upon these 3
events, in that order, the alarm will start a Carjack countdown. After a 60 second delay, the system will begin
chirping for 20 seconds then trigger into a full cycle for up to 5 minutes. To reset this Carjack mode, Ignition must
be ON then press and hold the override/program button for 5 seconds until LED goes out.
ONLINE TECHNICAL SUPPORT
www.crimestopper.com/techweb03.html
www.crimestopper.com
email@crimestopper.com
Phone (800) 998-6880
FAX (805) 581-9500
© 2004 Crimestopper Security Products