Crimestopper Security Products CS-2004DC Automobile Alarm User Manual


 
CS-2004TW1 / CS-2004DC II REMOTE PROGRAMMING
TRANSMITTER PROGRAMMING NOTES (Read first!):
(1) The CS-2004TW1 will learn up to 4 remotes, any combination of special CS-398TW 1-Way or CS-389LED 2-
Way pager remotes.
(2) The CS-2004DC II will up to 4 CS-404TX remotes. The remote controls for the CS-2004DC II and the CS-
2004TW1 systems ARE NOT interchangeable.
Remote Transmitters/Transceivers come pre-programmed to your system from the Factory. When re-learning
remotes or adding remotes, ALL your system’s remote codes must be learned at time of programming! These
systems allow storage of up to 4 different remote codes in memory. Note the slight difference in program step #4 for
either a 2004DC II or a 2004TW1 system. See steps below.
TRANSMITTER PROGRAMMING STEPS:
1. Turn key to the ON position and wait 5 seconds.
2. Press Programming/Valet button 4 times.
3. After a few seconds, the unit will flash the parking lights 4 times.
4. A. FOR CS-2004TW1: Press Buttons #1 & 2 together on the remote you wish to program.
B. FOR CS-2004DC II Press the Button #1 (Lock) on the remote you wish to program.
5. You should get 2 light flashes indication the unit is waiting for a 2
nd
code, then press buttons #1 & #2 of a
second transmitter, third or fourth or transmitter or transceiver. NOTE, the system will not flash the lights after
learning the fourth code. Turn key off to exit programming mode.
TRANSMITTER PROGRAMMING DIAGRAM ON NEXT PAGE.
16