Crimestopper Security Products CS-2004TW2 Automobile Alarm User Manual


 
WIRING
MINI PLUGS:
2-PIN PLUG (SMALL): LED INDICATOR (RED FLASHING LIGHT)
2-PIN PLUG (LARGE): PROGRAM/OVERRIDE PUSH BUTTON
4-PIN SENSOR PLUG:
RED WIRE: SENSOR +12V POWER
BLACK WIRE: SENSOR GROUND
BLUE WIRE: NEG. WARN AWAY
WHITE WIRE: NEG. TRIGGER
3-PIN BLUE SENSOR #2 PLUG: (For adding additional
PIN 1: SENSOR +12V POWER single stage sensors)
PIN 2: NEGATIVE (-) TRIGGER
PIN 3: SENSOR GROUND
3-PIN BROWN AUXILIARY/DOME OUTPUT PLUG:
ORANGE/BLACK WIRE: (-) DOME LIGHT ILLUMINATION OUTPUT (Optional)
Provides a Negative Output for 30 seconds upon disarming or until ignition is turned on whichever comes first. Use
this wire for illuminated entry into your vehicle. Connect to the Gray wire if you choose to use the on-board relay, or
this wire can be connected to an external relay [if the on-board auxiliary relay is being used for another function]. If
using on-board relay, see pages 4 & 5, or for external relay see following information:
Negative Dome Light System: Connects to terminal 85 of a relay. Connect terminals 86 +12V Constant.
Connect terminal 87 to Chassis Ground and Connect Terminal 30 to the Negative dome light activation circuit.
Positive Dome Light System: Connects to terminal 85 of a relay. Connect terminals 86 & 87 to +12V fused
Constant. Connect terminal 30 to the Positive dome light activation circuit.
NOTE: Dome light Illumination cancels the active rearm feature.
TIP: The Sensor supplied with
this system does not require
any additional wiring, simply
mount the sensor in a suitable
location, plug in, and adjust to
the desired levels of
sensitivity. The Black dial is
for Pre-warn level and White
dial is for Shock trigger.
6