Filter
Top Products
CARJACK PROTECTION
PROGRAMMABLE ACTIVE CARJACK
This feature provides Active remote-operated carjack protection and must be enabled before use through alarm
programming option #12. See page 13. When the Ignition is on (vehicle is running), press and hold Button #2
(Unlock) for more than 2 seconds. Parking lights will flash twice and LED will begin flashing to confirm the Carjack
countdown sequence. 30 Seconds later, the unit will begin a Carjack Cycle consisting of 20 seconds of pre-warning
chirps turning into a full system activation with siren/flashing light pulses for up to 5 min. If the Ignition is turned off
during a Carjack trigger, the siren and lights stop but Carjack protection is STILL active. The Siren and Lights will
resume if the Carjacker tries to turn the Ignition back ON. To reset Active Carjack, press Button #2 (UNLOCK) on
the remote and the siren will chirp once, or turn the key on and press and hold the override button for at least 5
seconds (or until the flashing LED shuts off).
PROGRAMMABLE PASSIVE CARJACK
This feature provides Passive Carjack protection and must be enabled before use through Alarm programming
options #7 & #12 on page 13. We recommend this mode should only be used in serious situations. When the
Ignition is on (vehicle is running), and a door is opened, then closed, the Carjack countdown sequence will
automatically be initiated. 60 Seconds later, the unit will begin a Carjack Cycle consisting of 20 seconds of pre-
warning chirps turning into a full system activation with siren/flashing light pulses for up to 5 min. To reset Passive
Carjack, IGNITION MUST BE ON, then press and hold the override button at least 5 seconds (or until flashing LED
shuts off).
SWITCH-CONTROLLED CARJACK PROTECTION (PINK WIRE CONFIGURATION)
NOTE: Carjack protection features using a switch on the PINK wire, operate independently of programmable
protection methods listed above
Pink wire must be connected to a hidden toggle or momentary switch providing +12V. This configuration will enable
the vehicle owner to activate a Carjack countdown by pressing a designated toggle switch or hidden button (not
included with kit) during a Carjack situation. A Carjack countdown will begin under the following conditions: Ignition
is ON (vehicle is running), the button or toggle switch is pressed FIRST, and a door opens & closes. Upon these 3
events, in that order, the alarm will start a Carjack countdown. After a 60 second delay, the system will begin
chirping for 20 seconds then trigger into a full cycle for up to 5 minutes. To reset this Carjack mode, Ignition must
be ON then press and hold the override/program button for 5 seconds until LED goes out.
26