Filter
Top Products
OPERATION
ARMING WITHOUT SHOCK SENSOR
To arm the alarm without Shock sensor protection, press Button #1 as normal then press and hold Button #4 (SLNT)
for about 3 seconds until the unit flashes the lights 3 times indicating shock sensor bypass.
EMERGENCY OVERRIDE/DISARM
If you have lost the transmitter or it stops working for any reason and the Alarm is armed, you will have to open the
door with the key, (activating the alarm), turn the ignition ON, press and hold the override/program switch until the
system disarms (about 7 seconds). The Alarm will disarm allowing you to operate the vehicle until you can
repair/replace the remote transmitter.
VALET MODE (VIA KEY or REMOTE)
Turn the ignition on and press and hold the program button for 5 seconds until lights chirps 3 times. The in-dash
LED turns on solid. Repeat the procedure to exit VALET mode. To activate Valet using the remote control, press
both the #1 (Lock) & #2 (Unlock) buttons together for 3 seconds when the system is disarmed. The system will chirp
3 times and the LED will turn off on Valet mode exit. Lock/Unlock and AUX features will still operate in when in
VALET mode. Use your remote to enter or exit valet mode even if you do not have a valet button.
VALET PARK Mode (Using the remote transmitter only)
Note: Valet Park mode is only accessible when using the remote transmitter. Valet park mode allows you to turn
over the vehicle to a valet, allowing access to drive/lock/unlock your vehicle, but alarm will trigger if the trunk is
opened. To activate Valet Park, press and hold both buttons #1 (Lock) & #2 (unlock) together for about 6 seconds.
3 chirps will be heard first when unit goes into regular Valet and as you continue to hold both buttons you will hear 2
more chirps. LED will flash slowly when in Valet Park. Repeat this step to exit Valet Park mode.
PRIOR INTRUSION ALERT
If the system was tripped in your absence, the dash LED will be flashing rapidly. When the system is disarmed you
will hear 2 chirps, a pause then 4 chirps. Carefully inspect your vehicle for any damage or theft.
PASSIVE ARMING / PASSIVE LOCK MODES (PROGAMMABLE)
If programmed, passive (Automatic) Arming will occur 30 Seconds after the ignition is turned off and the last door
has been closed. The lights will flash twice when the last door is closed and the LED will begin flashing rapidly while
counting down. If a door is reopened the countdown will reset and, the system will wait for the door or zone to close
before starting 30 second countdown again. The unit will chirp once and flash the lights once. Doors will lock if
passive locking is selected. This feature may qualify you for insurance discounts: Check with your insurance
provider. See programming options on page 13 for settings.
23