Filter
Top Products
STARTER DISABLE WIRING
STARTER DISABLE PLUG: (3) ORANGE 14 GA. WIRES:
(PROGRAMMABLE: Normally Closed or Normally Open Configuration with ON-Board Relay)
Note: READ BELOW before connecting starter disable! Normally OPEN must be programmed to operate. See pg 13.
Normally Closed Starter disable is the standard type used with most alarm systems today. This circuit will disable the
Starter while the alarm is armed or has been triggered. If 12V power is removed from the system or the Battery goes dead,
the relay will revert back to the closed position. (Factory Default)
Normally Open Starter Disable is a High-Security circuit that will disable the starter while the alarm is armed or triggered
AND if the unit is unplugged or removed from power. This means that if the vehicle’s Battery goes dead or the unit is
unplugged from the vehicle, the car will still not start. We only recommend this type of circuit if you can install a hidden high-
current toggle switch to defeat the Normally Open disable in case of a dead battery or if the unit is unplugged/removed for
service. (Toggle not included) See programming option #13 on page 13 to enable this type of starter disable.
CUT
START WIRE
STARTER
ORANGE
IGN
SWITCH
ORANGE
ORANGE
N/C
N/O
COM
NOTE ALIGNMENT OF PLUG
N/C = NORMALLY CLOSED
NORMALLY CLOSED STARTER DISABLE (DEFAULT)
CUT
START WIRE
STARTER
ORANGE
IGN
SWITCH
ORANGE
ORANGE
N/C
N/O
COM
NOTE ALIGNMENT OF PLUG
N/O = NORMALLY OPEN
HIDDEN TOGGLE
SWITCH
**JUMPER #7 MUST BE
REMOVED!**
(NOT INCLUDED)
NORMALLY OPEN STARTER DISABLE (OPTIONAL)
1
0