Filter
Top Products
CONTROL MODULE / COMPONENT MOUNTING
DO NOT Mount the control unit or wiring harness in the engine compartment or anywhere they can become
entangled with moving parts such as brake/gas/clutch pedals, or the steering column. The alarm control module
should be mounted in a concealed location. The antenna wire should be routed away from any metal if possible.
Do not alter the length of the antenna, ground it, or route it with other wires.
SIREN MOUNTING: Mount the siren under the hood to fender-well or other body surface with the open end facing
downward. Run the red siren wire through the firewall using a rubber grommet. Ground the black wire to the body.
LED: Mount the LED in a visible location on the dashboard or console.
Shock Sensor: Mount the included shock sensor with wire ties to an under dash wire harness or fasten with screws
to firewall or side paneling.
Override/Program Button: Mount the Override/Program push-button in a hidden but accessible location. It is used
for emergency disarm without the use of the transmitter and for programming certain features.
WIRING
RED WIRE: +12V POWER INPUT (15 Amp Fuse)
Connect to a +12 Volt source with the supplied fuse and fuse-holder. We recommend the connection to be at the
Vehicle’s Battery Positive Terminal.
BLACK WIRE: CHASSIS GROUND
THIS WIRE MUST BE CONNECTED TO THE CHASSIS METAL OF THE VEHICLE. Scrape away any paint or dirt
to ensure a good connection.
YELLOW WIRE: IGNITION SWITCHED “ON” and “START” +12 VOLTS
Connect to a (+) Ignition wire that shows +12 Volts when the key is in both the “ON” and “Cranking” positions.
ORANGE WIRE: (-) NEGATIVE ARMED OUTPUT
This wire becomes a Negative Ground output when system is armed. This output can be used for additional starter
disable relays or to activate other devices such as scanner LED’s, window modules, voice modules etc.
WHITE WIRE: +12V FLASHING PARKING LIGHT OUTPUT (10A)
Connect to the switched parking light wire at back of light switch or connect directly to one of the parking lights at the
front of the vehicle. European vehicles may require additional parts due to separate left and right circuits.
BROWN WIRE: (+) SIREN OUTPUT (3 Amp Max.)
3
Connect to the siren’s RED wire. Connect the Siren’s Black Ground wire to the chassis close to the siren.