Crimestopper Security Products CS-2004TW1 Automobile Alarm User Manual


 
OPTION PROGRAMMING
9. OPEN DOOR/ZONE WARNING (5 or 60 Seconds)
This setting changes the delay time in which the alarm system begins to monitor the Door Zone. This is helpful on
vehicles with delayed dome lights. It prevents the alarms warning chirps due to extended dome light circuit.
10. DOOR LOCK/UNLOCK PULSE TIME
Controls the amount of time (0.75 sec. or 3 sec.) for the lock/unlock pulse. The 3 sec. setting may be required for
1980’/90’s European Vehicles that require a long pulse to operate Vacuum door lock systems.
11. DOUBLE UNLOCK PULSE
This option controls whether the unit will send one or two unlock pulses when disarmed. This feature may be
required for interfacing to existing Factory Keyless Entry or Alarm systems in a vehicle. These systems are found
on some Nissan, VW, Toyota, and Lexus vehicles.
12. ENABLE/DISABLE CARJACK FEATURES
This option controls the unit’s Car Jack features. Enable or Disable Carjack (Turn ON or OFF) with this option.
13. STARTER DISABLE CONFIGURATION: NORMALLY CLOSED OR NORMALLY OPEN
This option controls the unit’s on-board Starter disable relay for either “Normally Open” or “Normally Closed”
operation. See page 10 for more information.
14. ALLOW ARM/DISARM WITH IGNITION ON
This option controls whether the unit will allow arming and disarm using the remote when the ignition is on (or
vehicle is running). This program option may need to be enabled when using an Add-on remote starter to allow the
alarm to be armed or disarmed after remote engine starting.
PROGRAM OPTION RESET
This system provides a “reset method” to restore all options to FACTORY DEFAULT VALUES as listed in the
“Button #2” column of the programmable option chart on page 13. This can be helpful if you have lost track of the
option settings on your system or when you are moving systems from car to car.
1. Turn Key to the ON position, wait 5 seconds.
2. Press program / valet button 5 times, after a few seconds the unit will flash the lights 5 times.
3. Push the valet/program button 15 times. Press button carefully. You must get a light flash each time you press
the button. If the unit didn’t flash the lights, then it did not register your press.
4. Press button #2 (Unlock) to reset the options. Lights will flash twice.
15
5. Turn Ignition OFF. All features should be set at “*DEFAULT” values.