Filter
Top Products
TRANSMITTER PROGRAMMING
This system will learn a maximum of 3 transmitters total.
1. Turn Ignition ON/OFF…ON/OFF …ON. You should hear (3) chirps.
2. Press the Program/Override Button 5 times and you should hear 5 light flashes and 5 siren chirps. (System is now
in transmitter programming mode.)
3. Press the LOCK Button on the transmitter two times:
a. First press gives 1-siren chirp
b. WAIT 3-5 seconds, press the LOCK BUTTON again, and the siren should chirp twice. (Code learn
confirmation.)
NOTE: If you do not receive 2 chirps on the second press of the button, just press it again until you hear 2
chirps. Your system may not learn the remote until you pressed it a 3
rd
time.
4. Repeat step #5 above for up to 2 additional transmitters, or turn Ignition OFF. Siren will chirp 3 times and lights will
flash 3 times when exiting the transmitter programming mode.
Note 1: Previous software versions follow the same steps above with one exception: You are only required to press
the lock button ONCE at step #3 on older software systems. New Transmitters will work on previous versions but old
transmitters will not work on the latest version. Current and control modules will be identified with a GREEN dot.
Note 2: If you are using this identical alarm system in two vehicles, you can program button 4 (PANIC) from the
OTHER vehicle’s remote to Arm/Disarm THIS alarm system. Follow steps above, but press the OTHER vehicle’s
remote Button #4 (PANIC) 2 times in step 3. The other vehicle’s remote transmitter will only ARM/DISARM with Button
4 and not perform any auxiliary or special features on THIS system.
DIAGRAM:
IGN
OFF
PANIC
TURN IGN. ON
3 TIMES:
ON, OFF
ON, OFF
ON.
5 CHIRPS
PRESS
BUTTON
5 TIMES
PRESS LOCK
BUTTON 2 X's
5 FLASHES
(CODE LEARNED)
IGN
OFF
LEARN
ANOTHER
REMOTE
OR
3 CHIRPS
1st = 1 CHIRP
2nd = 2 CHIRPS