Filter
Top Products
OPERATION
OPEN ZONE ALERT/BYPASS
If the system detects a faulty or open zone (Door left open) when the system is ACTIVELY ARMED, the siren will chirp
4 times along with 4 light flashes. The faulty zone will be automatically bypassed.
IGNITION-CONTROLLED DOORLOCKS
The doors will automatically lock when the ignition is turned on and will unlock when the ignition is turned off. This
feature can be programmed on, off, or to lock the doors only. Doors will not lock if they are open to prevent locking
the keys in.
ACTIVE RE-ARMING (FAIL-SAFE PROTECTION)
Active Re-arming means that the system will re-arm itself 30 seconds after disarmed with the transmitter if a door has
not yet been opened. This is handy if the vehicle is accidentally disarmed (via the transmitter in your pocket) without
you knowing it. This feature can also be turned off in programming option (4).If programmed for Passive Chirp
Countdown, the unit will emit a chirp every 2 seconds until the system Active Re-arms.
2
nd
AUX. OUTPUT (REMOTE AUX. OUTPUT 2)
To activate the Second auxiliary output press Button #1 (Lock) and hold for more than (2) seconds. This output can be
used to control optional add-on accessories such as Remote Engine Start Modules, Window Roll up/down modules,
etc.
2 VEHICLE OPERATION
2 VEHICLE CONTROL
Your remote control can be programmed to Arm/Disarm a second vehicle with an identical Crimestopper
system installed. Follow transmitter programming steps on the second vehicle. Instead of pressing the #1
Lock at step 3, press Button #4 (Panic) on YOUR existing remote. Your remote will now have arm/disarm
control of the second vehicle with a quick press and release of your Button #4 (Panic). Don’t press the Panic
button for too long or YOUR alarm system will trip. You can only arm/disarm the second vehicle.
CARJACK PROTECTION
ACTIVE CARJACK
This feature provides Active Carjack protection and must be enabled before use through Alarm programming
option (14) See page 9. When the Ignition is on (vehicle is running), press button #4 (Panic). Parking lights
will flash TWICE to confirm the Carjack countdown sequence. 90 Seconds later, the unit will begin a Carjack
Cycle consisting of 15 seconds of pre-warning chirps turning into a full system activation with siren/flashing
light pulses for up to 5 min. To reset Active Carjack, IGNITION MUST BE ON, then press Button #4.